Die Setter 2nd Shift

Job Duties

• Install dies, ensuring that bolster and die are clean, and properly aligned.
• Calculate and adjust press shut height, cushion pin length, take lead readings and ensure first off is correct.
• Load coils onto uncoiled, adjust feeder, thread coil into feeder head and ensure that steel is properly aligned with die.
• Calculate and adjust knock-outs and catchers, set up part ejectors and scrap removal systems.
• Make necessary die adjustments.
• Operate lift trucks and overhead crane, and use hand tools and measuring instruments as required to carry out duties.
• Pre-stage dies and equipment for next set up.
• Ensure good housekeeping at all times.
• Adhere to all relevant Company policies, procedures and instructions.
• Must be familiar with and follow all required procedures required for this position.
• Other duties as assigned.

Requirements

• High school diploma or GED required.
• 2+ years of experience as a die setter or in a similar role in a manufacturing environment, preferably automotive.
• Experience with stamping presses or other relevant production equipment.
• Experience in mechanical press setup, die setting and basic press maintenance.
• Practical knowledge of entire operation of the press from the feeder and uncoiling equipment to first off.
• Ability to safely operate all equipment required.

Requirements

• High school diploma or GED required.
• 2+ years of experience as a die setter or in a similar role in a manufacturing environment, preferably automotive.
• Experience with stamping presses or other relevant production equipment.
• Experience in mechanical press setup, die setting and basic press maintenance.
• Practical knowledge of entire operation of the press from the feeder and uncoiling equipment to first off.
• Ability to safely operate all equipment required.