Engineer

Support
Provide Tier IV Level support and provide aid to any issue that may occur in your area or on the projects youre working on.

Engineering & Design
Read, interpret, review, and redline P&IDs, Electrical and Instrumentation Schematics.
Participate in design review of all projects.
Led a automation (controls) focused PHA
Take complete ownership of Tagging, Symbols and References for all projects
Key equipment design parameters design/ operating pressure; design/ operating temperature.
Hardware selection of key hardware components
Instrumentation suitability for the selected parameters; ranges; alarm set points; trip set points
Control panel interfaces signals to/ from main control room and field instruments; hardwired signals; serial linked signals
Control loops between the instruments and equipment
Ensure project requirements, expectations, or operational points are within WIMS operating philosophies & standards
Author and ensure consistency between documents such as instrument index, control philosophy, programs, and C&E.
Review of P&ID to check consistency with ESD philosophy
PLC Programming
Write Logic for SCP and ESD PLC
Write logic all transmitters and devices
Write Logic for all compressors
Write Logic for Scada Packs
Write Logic generators
Write Logic for Vent Fans
Write Logic for Gas Coolers
Write Logic for Gas Control
Write Logic for Power monitor
Write Logic for air compressors
Write Logic for ESD
Write Logic for Fire and Gas Detectors
Setup all devices and input IP addresses
Order and Procure Modules and devices for project
Request IP address allocations from IT
Gas Control Data Test, Point to Point and final data review.
HMI Automation
Create Screen and alarms for SCP and ESD PLC
Create Screen and alarms all transmitters and devices
Create Screen and alarms for all compressors
Create Screen and alarms for Scada Packs
Create Screen and alarms generators
Create Screen and alarms for Vent Fans
Create Screen and alarms for Gas Coolers
Create Screen and alarms for Station Control
Create Screen and alarms Daily Report
Create Screen and alarms for trending
Create Screens alarms for ESD , Fire and Gas
Order HMI Machine for Wonderware
Order Wonderware License

Fat Testing
Travel and Conduct Factory acceptance test of Control buildings
Travel and Conduct Factory acceptance test of Control Panels
Travel and Conduct Factory acceptance test of Motor Control Centers
Documents
Maintain, test, verify, cause and effect, and IO list.

Commissioning
Travel and commission the entire station controls and automation system.
Test and commission every device tied into the control system as mentioned in PLC Programming and HMI Automation.
Test and commission Scada

Experience:
8-10 years of experience preferred
5 years of experience is minimum
Prior oil and gas experience