The work products and services to be provided, including any specific HMIS standards and requirements, required
for the successful completion of this work activity include the following:
• If necessary, an onsite scheduled visit to become familiar with equipment and discuss support needs.
• Three scheduled support visits at approximately 4-month intervals. The approximate length of each visit
will be 4 days and all visits to HAMMER shall be coordinated, supervised and pre-arranged with the
HAMMER Operations Department.
• Site visits shall be by a trained technician to evaluate the fire training equipment and implement all
scheduled adjustments and parts replacements to ensure that the system is at a fully operational state.
Page 4 of 28
General Materials or Services- Rev 4 10/23/2025
The service will include the following:
• Check the operating performance of all fireplaces and adjust as required.
• Clean and/or replace all filter elements.
• Inspect all fans and blowers and lubricate all bearings.
• Inspect all pilot spark igniters and replace as required.
• Inspect all pilot spark flame rods and replace as required.
• Inspect the fuel control station and adjust as required.
• Clean the fuel control station inlet strainer.
• Inspect all gas detection assemblies.
• Inspect and adjust all smoke generators.
• Inspect the Programmable Logic Controller battery and replace as required.
• Clean all equipment cabinets.
• Visually inspect all element piping and replace as required.
• Function test all Field Fire Props.
• Inspect Field Fire Props and perform repairs as required.
• Provide overview of fire prop maintenance and operation to HAMMER maintenance and Hanford Fire
Department (HFD) personnel as required.
• Provide initial and refresher burn prop operator training to qualified HAMMER/HFD personnel as
identified by HAMMER Operations Manager.