Essential Duties and Responsibilities: Write, change, and test control programs in Opto 22 PAC Control (flowcharts and OptoScript) on groov EPIC and SNAP PAC controllers for new equipment and line changes.Support and troubleshoot Allen-Bradley PLCs (RSLogix 500 / Studio 5000) on the equipment that uses them.Update HMI screens (groov View / PAC Display), alarms, and operator messages.Load and start up program changes on running lines without causing unplanned downtime.Keep a current, labeled backup (date, reason, name) of every controller and HMI program, and fix any mismatch with the running program.Set up and tune VFDs, sensors, and scales.Read schematics and build, wire, and terminate control panels and field devices.Run conduit and cable to plant and food safety standards, and check all wiring against the print before powering up.Mark up prints when field wiring doesn't match the drawing and submit the change.Install and test safety devices such as e-stops, light curtains, and safety relays.Respond to line-down calls, find the cause (electrical, mechanical, or logic), and get the line running again.Record the cause and fix in the maintenance system, and recommend permanent fixes for repeat problems.Complete scheduled inspections of panels, drives, and sensors.Always follow lockout/tagout, NFPA 70E arc flash rules, GMPs, SQF, and sanitation rules.Train operators and maintenance staff on common faults and recovery steps.Education and/or Work Experience Requirements: 3+ years of hands-on PLC work in a manufacturing or processing plantOpto 22 programming experience (PAC Control, groov EPIC or SNAP PAC), or strong PLC programming experience and the ability to learn Opto 22Able to read schematics and I/O drawings and wire control panels and field devicesNFPA 70E / arc flash training, or complete it within 60 days of hireLOTO-qualified, or become qualified within 30 days of hireHigh school diploma or GEDAvailable for overtime, weekends, callouts, and on-call rotation, especially during harvest seasonCalifornia electrician certification is not required. Preferred:Allen-Bradley RSLogix 500 / Studio 5000 experiencegroov View, Ignition, or other HMI/SCADA experienceVFD setup experienceFood, beverage, or fresh-cut processing experienceTechnical degree or certificate in automation, electronics, or a related fieldBilingual English/SpanishPhysical Requirements: Work in wet, cold (34–45°F), loud production areasStand and walk most of the shift; lift and carry up to 50 lbsBend, kneel, reach overhead, and work in tight spacesClimb ladders, work from lifts, and enter confined spaces with a permitWear required PPE, including hearing protection, arc flash gear, and food safety garments