Quality Control Inspector

Job Description: 100% onsite at New Port Richey FL
Shift Mon-Fri - 8: 00am-4: 30pm
top 3 must-have skills or qualities in a candidate:
Able to use calipers, micrometers, height gages, comparator oscilloscopes, and other measuring devices
Experience in AS9100, ISO9001
Willingness to work overtime

ESSENTIAL JOB FUNCTIONS

Perform first piece, receiving inspection, in process inspections, and source inspections as required. Operate CMM (coordinated measuring machines), using calipers, micrometers, height gages, comparator oscilloscopes and other devices to inspect purchased and manufactured parts, subassemblies, final assemblies and first article inspections, as required.

Document inspection findings as needed in corrective action reports.



Complete First Article Inspections (FAIRs) Create FAIRs reports.



Work under the direction of supervisors or more experienced personnel with little supervision.

Communicate ideas, problems, and concerns to management.

Perform Kamishibai daily.

Understand and follow verbal and written instructions.

Complete all necessary paperwork as required including scorecards, hazard recognitions, routers and data.

Perform other tasks as assigned.

Work overtime as required.



MINIMUM QUALIFICATIONS

Must have a high school diploma or equivalent (i.E. GED).

Minimum of five (5) years of quality assurance inspection experience within a manufacturing high mix and complex product environment.

Working knowledge and experience in AS9100, ISO9001, Repair Station, FAA (Federal Aviation Administration) regulations, PRMRB (Preliminary Review and Material Review Boards) and QMS (Quality Management Systems) processes.

Demonstrated ability to perform multiple tasks in a fast-paced manufacturing environment with high mix and complex products.

Familiar with Discus First Article software and Net Inspect.

Knowledge and experience using SAP or other ERP systems.

Experience using Mauser/Zeiss/Mitutoyo/Brown and Sharp CMMs.

Knowledgeable and experienced in interpreting complex electrical and mechanical engineering part drawings and GD&T (Geometric tolerancing).

Highly skilled with calipers, micrometers, micro-hite, comparators, height gages, verniers, and surface finish measuring instruments, comparator oscilloscopes, and other precision instruments.

Experience with First Piece Inspection, Final Inspection, Receiving inspection and Source inspection.

Computer literacy in MS Office (i.E. Excel, Word, Outlook, Data Entry).

Able to travel (domestically) to visit the customer as well as for training (10%).

Ability to write CAPAs

Ability to create DIR/DIPs using correct AQLs based of customer flow down requirements.

Work overtime and flexible hours as required.



PHYSICAL REQUIREMENTS

1. Bending, lifting, sitting, standing and twisting for long periods of time.

2. Successfully pass the Ishihara s Test for Color Deficiency, and Jaeger Level 1 examinations.

3. Must have a minimum of a 20/25 vision (with correction).

4. Required to lift a minimum of 30 pounds. Lifting frequency: Daily.

5. Good eye and hand dexterity.

6. Frequent standing or sitting for extended periods

7. Bend, lift, sit, twist and/or stand for long periods of time

8. Must be able to work with solvents, oils, and other chemicals as required