Set-up, operate, and trouble shoot a variety of machines including CNC, VMC, and SWISS machines. Responsible for first inspection and inspection during production, and responsible for updating and maintaining set-up sheet and program.
2nd Shift wage premium!
Responsibilities:
Set-up machines following blue prints and according to work order
Load material on machines as needed: band and wire on slide form, radiator, multiplex, large and small dial; coil on punch press, cut off machine; strips on automatics, punch press; sheets on slitters, shears, perforators; bars on automatic feed saw; bath in plating; parts on groovers
Fine tune machine until product passes first inspection
Operate machine if required: feed band on automatics, assemble two plates and a stem on the hand weld machine
Read, understand information in workmanship standards
Fill out appropriate sections of work order
Handle, store, use micrometers, calipers, gages appropriately
Perform and document S&R inspection procedures when appropriate (SPC charts, work orders, move tickets)
Identify nonconforming product or material
Wash tools and return to storage area
Oil, lube, clean and perform minor repairs as needed
Communicate with tool room or maintenance as required by supervisor
Assist with training of Operator persons as needed
Know and follow safety standards
Participate in corrective actions as required
Move parts to next operation
Remove scrap
Operate pallet trucks
Physical and Visual Activities:
Standing, walking, sitting, lifting, carrying, pushing, pulling, balancing, stooping, kneeling, crouching, crawling, reaching, handling, fingering, feeling, talking, hearing, visual acuity-far/near depth perception, field of vision and accommodation
Physical Demands:
Lift up to 75 pounds
Environmental/Atmospheric Conditions:
Indoor conditions, noise, hazards, odors, toxic conditions, dust, and periods of travel to support company's international facilities may be required
Job Qualification Requirements:
Knowledge/Experience
High school graduate or equivalent; reading, basic math, blueprint reading
Three to five years' experience with metal stamping, wire forming machinery
1-2 years operating CNC machines
1-5 years setup experience, Swiss Lathe experience preferred
Tool design, machine repair helpful
Ability to lead/train
Training Period: 3 months to a year
Machines, Tools, Equipment
CNC, hand tools, measuring instruments, surface and bench grinders. Lathe, mill, and drill press experience helpful
Information/Directions
Written and verbal work instructions, workmanship standards book (engineer drawings), quality control documentation (work orders, move tickets)