Quality Control Density Technician S.T. Wooten CorporationQuality Control Density TechnicianSmithfield, NCFull timeQuality control programs and testing of varying materials including, but not limited to: ready mix concrete, asphalt, aggregates, sand, borrow, and recycled materials. Heavy physical effort required including pulling and lifting or moving heavy weight material with frequent lifting or moving materials or equipment (over 80 pounds).
Environmental Health & Safety Technician Wolfspeed IncEnvironmental Health & Safety TechnicianDurham, NCObtain necessary information to assist Environmental Manager or Engineer(s) in identifying waste, waste generating process from internal generators then either assign to existing outbound waste profile or work with them to complete and submit new outbound profile. This Job is Right for You if You Have (Minimum Requirements): 3-years hazardous materials or waste experience either at LQG, TSDF, or in Field Services (ie: chemical cleanup, emergency services, HAZMAT responders, or similar) capacity.
EMS Technician Wake County North CarolinaEMS TechnicianRaleigh, NCThe events in the test consist of unbuckling a seatbelt and exiting a vehicle from the driver's seat; stretcher lift simulation (using a 95-lb curl bar); stretcher movement with equipment 100ft (50ft down and 50ft back) over curb stops bolt to the floor; stretcher stair carry simulation (using a 95-lb curl bar); equipment lift and place; equipment movement/transfer (which includes kneeling 8 times); patient drag (using a 150-lb manikin strapped to a backboard) a total of 100ft; chest compressions (2 minutes of chest compressions at a rate of 120 a minute); repeat stretcher movement; climbing into the back of ambulance through side door. Hazmat Gear Requirements: Due to the unpredictability of the hazards encountered in the course of work, the applicant must be able to successfully fit test in, wear and perform essential job functions in respiratory personal protective equipment including, but not limited to, NIOSH-certified N95/P100 air-purifying respirators and a full-face tight-fitting respirator with the appropriate air-purifying cartridge.
Environmental Health & Safety Technician WolfspeedEnvironmental Health & Safety TechnicianDurham, North CarolinaObtain necessary information to assist Environmental Manager or Engineer(s) in identifying waste, waste generating process from internal generators then either assign to existing outbound waste profile or work with them to complete and submit new outbound profile. 3-years hazardous materials or waste experience either at LQG, TSDF, or in Field Services (ie: chemical cleanup, emergency services, HAZMAT responders, or similar) capacity.