Co-Op: Software Engineering

The student will be exposed to the engineering design process by being given assignments of increasing scope and responsibility over the course of his/her coop career at Fives Machining Systems, Inc (FMSI).

Job responsibilities will encompass:

• Design and analysis of machine tool products, with follow-up during assembly and unit/prototype testing in lab environments and or the production shop floor.
• Depending on the specific engineering discipline, the student will acquire skills in the following:
• Understanding design input requirements
• Analysis of design, for both subsystem and system level products
• Drafting practices and standards 3D modeling and 2D drawing creation
• Creation of Bill of Material Release Authority Design verification/validation testing
• Interfacing with the Controls Electrical engineering teams
• Participating on cross functional project team

The student will also be exposed:

• Continuous improvement and customer satisfaction activities
• Root cause problem analysis
• Design review techniques
• Failure modes and effects analysis
• Hazard analysis

This FMSI co-op position is for the Fives Cincinnati facility. The facility is located at 2200 Litton Lane, Hebron KY, within 5 minutes of the Greater Cincinnati Airport, CVG.