Technology Quality Technician

Description:
The Technology Quality Technician is responsible for conducting quality control activities, including inspections, tests and results reporting.
The Technology Quality Technician combines practical skills with understanding of the overall Quality Management System and the impact of nonconformances on the performance of equipment and systems.
Inspect documentation, parts, components, materials, subassemblies and equipment against stated specifications, using measurement systems (including CMM) with valid calibration and acceptable repeatability and reproducibility.
Comply with applicable inspection procedures and standard work.
Assist in designing tests and fixtures and their set-up.
Ensure all inspection and test activities are conducted safely. Participate in creation and review of Hazard Analysis and Risk Control for these activities.
When authorized, perform calibration of measurement systems.
Be familiar with inspection and test procedures, standard work and test plans, and provide input to continuously improve them.
Document the results of inspections and tests. Verify the stability of results over time, as feasible. Use the guiding principles and tools of the Manufacturing System to drive continuous improvement, wherever applicable.

Key Responsibilities
Perform inspections on machined metal parts (primarily tubular components, under 8 inches diameter and up to ~5 feet long)
Operate CMM (Coordinate Measuring Machine) for inspections
Potential exposure to programming (nice-to-have)
Conduct manual inspections
Interpret mechanical drawings and specifications
Document inspection results and communicate findings, including nonconformances
Collaborate with engineers on inspection outcomes

Required Experience & Skills
Must-Have:
Experience with CMM operation (Zeiss preferred)
Ability to read and interpret mechanical drawings
Hands-on dimensional inspection experience
Strong attention to detail
Good verbal and written communication skills

Nice-to-Have:
CMM programming experience
SAP experience
Zeiss certification
Experience in oil & gas or similar manufacturing environments

Required Years of Experience
2-3 years of CMM and mechanical inspection experience

Education Requirements
High school diploma or GED

Shift / Hours
1st Shift: 6:00 AM - 2:30 PM, Monday - Friday
Minimal overtime

Interviews
In-person interview before final decision