Job Responsibilities: Inspect LED modules and identify dead, damaged, dim, discolored, intermittent, or misaligned pixels Remove and replace individual LED pixels and other surface-mount components Perform precision soldering and rework using microscopes, hot air stations, soldering irons, preheaters, and specialized tools Repair damaged solder pads, traces, connectors, and minor PCB damage when a reliable repair is possible Verify pixel polarity, orientation, alignment, solder quality, color, brightness, and reliable operation Clean and test completed repairs using approved LED test equipment and test patterns Document defects, repairs performed, parts used, module information, and final test results Prioritize urgent repairs to support upcoming shows and close equipment turnaround schedules Maintain an organized, clean, and ESD-safe work area and report recurring failures or parts shortages Perform other related electronics repair duties as assigned by the supervisor. Electronic soldering and surface-mount rework experience required Experience using microscopes, hot air rework stations, soldering irons, flux, solder wick, and precision hand tools Strong fine motor skills, close visual attention, and the ability to perform repetitive precision work for extended periods Ability to identify component polarity, orientation, solder quality, damaged pads, and basic PCB faults Ability to distinguish small differences in pixel color, brightness, alignment, and performance Ability to work efficiently while maintaining consistent repair quality in a fast-paced environment Good computer, organization, documentation, and communication skills Ability to work independently with minimal supervision and a strong sense of urgency Direct LED pixel replacement experience and familiarity with ROE Visual or other professional LED products preferred Final candidates may be asked to complete a practical soldering and pixel replacement assessment.