Minimum Qualifications: B.S. degree or higher in Mechanical or Aerospace Engineering Experience in Production Support Engineering 5-10+ years of recent experience designing aerospace or equivalent type mechanical system elements within aircraft, spacecraft, or launch vehicles Strong mechanical design and integration skills using 3D modeling tools Experience with GD&T (ASME Y14.5) Ability to earn trust, maintain positive and professional relationships, and contribute to a culture of inclusion Knowledge of fabrication, integration processes, and quality control relative to tubes/piping and machined components Confirmed understanding of materials and treatments Experience and ability to work independently on rapid development programs Must be a U.S. citizen or national, U.S. permanent resident (current Green Card holder), or lawfully admitted into the U.S. as a refugee or granted asylum Preferred Qualifications: Experience in primary flight control actuator design Experience in primary structures design Experience in aerospace deployable devices design such as doors, landing gear or sensors Experience in aerospace hydraulic system component design or system architecture design Experience in spacecraft separation systems design Experience in Creo (Pro-E) Experience in structural FEA using ANSYS, NASTRAN or similar tools Experience leading at least 1 multi-person development project, leading requirements, priorities, scope, schedule, cost, and communications Culture Statement Dont meet all desired requirements? and/or transports placardable amounts of hazardous materials by ground in any vehicle on a public road while in commerce, may be subject to additional Federal Motor Carrier Safety Regulations including: Driver Qualification Files, Medical Certification (obtained before onboarding), Road Test, Hours of Service, Drug and Alcohol Testing (CDL drivers only), vehicle inspection requirements, CDL requirements (if applicable) and hazardous materials transportation/shipping training.